Beginner Tips and Tricks

Beginner Tips and Tricks | September 26, 2017 | United States



Simple techniques to improve weld quality, safety, and efficiency.

Beginner Tips and Tricks Department Header

image
Larry Sorenson, Altoona, Pennsylvania

Effect of Welding Current

One welding variable that has a big impact on the degree of weld penetration is current. As welding current increases (i.e., amperage is higher), weld penetration increases. Conversely, as welding current decreases (i.e., amperage is lower), weld penetration decreases.

Jared Stauch, Fort Erie, Ontario

Prep for Success

– JARED STAUCH, FORT ERIE, ONTARIO

Prepping your metal is the first step to success. This can help prevent any headaches as you get into the weld. Rust, paint, water and other contaminants affect your weld bead and penetration. Keeping the metal and the work area clean will help get the proper penetration and weld profile you need.

John Schechtman, Earlville, Iowa

Check your Hood

Hold your welding helmet toward the sun or a light occasionally to inspect the shell for cracks or pin holes. If light comes through the helmet, replace it. The smallest pin hole can result in quite a bit of sunburn on your face and neck.

Neitan Perex Figueroa, Adjuntas, Puerto Rico

Check the Polarity

To achieve a better quality weld, make sure to switch polarity between MIG solid wire (direct current electrode positive, DCEP) and inner shield flux cored shelf-shielded wire (direct current electrode negative, DCEN).

image
image
Diego Espinoza, Yuma, Arizona

Avoid Distorition and Discoloration

If you need to weld stainless steel, it’s a good habit to clamp blocks of aluminum behind and around the weld joint. The aluminum blocks serve to draw heat out of the material, since aluminum has a higher thermal conductivity than stainless. Using chill blocks can reduce distortion and discoloration on the welds. Also, it may prevent sugaring on the backside of the weld, especially on thin material when back purging is not used.

Eric Pescetta, Ludlow, Massachusetts

Small Differences, Big Discrepancies

Sometimes it’s easy to overlook the small things when you’re in a big shop. While working with a partner, it’s always a good idea to compare tape measures. Oftentimes, two tools can be off by a 1/32nd or even 1/16th of an inch. It may not seem like a lot in the context of an inch or two, but those inconsistent fractional hash marks add up to some big discrepancies over the course of 50 feet. You might even suggest that everyone in the shop use the same model of tape measure from the same manufacturer – and maybe even replace them at certain intervals as the hash marks fade or become unclear.

image
image